
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don’t
change the page numbering. Keep the language
integrity.
Attention: do not fill the tank beyond the level required.
3. Place the receptacle on its base in the correct manner: ensure that the two arrows match up (on the
base and on the receptacle, found at the back).
4.
Ensure that the knob is in the “0” position (off): and most importantly that the water has not
overflowed.
5. Plug the appliance in.
6. Turn the knob (3) in a clockwise direction to the “min” position and corresponding to the amount of
nebulisation required: minimum, intermediate or maximum. After a few seconds, vapour will start
forming.
7. When the water runs out, the nebuliser will automatically stop: to fill up the receptable again,
follow the instructions above in paragraphs 1, 2, 3 and 4.
8. For ozonation, press the “ozone” button (9) completely. To stop it, press it again and release.
9. To diffuse perfumes, extract the filter carrier from the base (11), moisten the felt (12) with a few
drops of essential oils and insert the filter carrier once again in its proper place. Be careful not to
add too much oil so as to prevent damage to the surface and the appliance itself. Do not add the
essential oils to the water in the receptacle or inside the unit.
10. In order to turn the appliance off, turn the knob to the “0” position, turning it in an anticlockwise
direction and unplug the unit from the power source.
11. After each use, empty out any water that may have collected in the tray inside the base and dry it
using a soft cloth
If the device is not to be used for a long time, remove the plug from the electric outlet and make
sure the tank and inside of the base are perfectly dry.
Warning: if you do not plan to use the appliance for two or more consecutive days, make sure that
the tank and the tray have been completely drained. Dry them to prevent the formation of bacteria and
algae in the stagnant water
CLEANING AND MAINTENANCE
Warning: before cleaning the applinace ensure that it is turned off and unplug it from the power
source.
Descaling
To prevent the formation of bacteria or deposits, and to increase the lifespan of the humidifier and its
components (ceramic filter etc), remove any limescale deposits that may form (more frequently if the
water is hard) or other impurities.
Ceramic filter (perform monthly)
1. Remove the lid of the receptacle, unscrew the ferrule (5) from the filter (7) in an anticlockwise
direction.
2. Place the filter in a container with white vinegar (8 degrees) or a descaling agent for 10 minutes.
3. Rinse the filter carefully under running water, and after allowing it to drip dry, screw it back onto
the receptacle.
Receptacle (perform weekly)
11/32
Assembly page 11/32
Comentarios a estos manuales